Hate Hydraulic Adhesion Tester is one of the most accurate and
versatile adhesion testers currently available.
The adhesion is measured by the required
tensile pull on a Dolly glued to the coating surface. The force is
applied through the centre of the Dolly by a hydraulically loaded pin.
Connection to the stainless steel Dolly
is easily made with a snap on connector. The pressure is swivel
mounted allowing testing in any position, this is significant as
coating breakdown invariably starts at positions that were difficult
to reach during surface preparation and application.
Tests can be made on flat, concave and
convex surfaces. Dollies can be supplied for measuring on the external
and internal radius.
Conforms to ASTM and ISO methods of
measurement with an accuracy of ¡Ó1% of pressure gauge FSD.
Maximum value at pull off is recorded by
a red drag indicator.
Range 0 - 3,500 psi, 0 - 25MPa, 0 - 250 bar.
The Hate Adhesion Tester is supplied in
a Carrying Case with 5 Flat Dollies, 5 Nylon Plugs, Drill to Clear
Dollies, Adhesive and Dolly Remover / Cleaner.
1003 - Hate Adhesion Tester
X001 - Calibration Certificate UKAS Traceable